
57
Chapter 4, How to Build a PC Water-Cooling System
board. Check this data against the lists of CPUs and
motherboards found on web sites such as http://www.
hardocp.com/ and the others listed at the end of this
chapter.
You can also check for overclocking compatibility by
restarting the PC into the BIOS screen. To do this, press
the F4 key just after the PC starts up. Look through the
various options for the one that lets you change the clock
speed. Most Pentium and AMD processors rated for
200MHz-plus installed in the motherboard and made in
the past four years can be overclocked. Search the forums
in the web sites listed at the end of this chapter for confir-
mation of your hardware.
Hardware Assembly Instructions
Follow these six steps to build your overclocked PC with
water-cooled processor.
1. Build the water block
The water block is a waterproof metal can connected to a water pump that is
attached to the CPU in your PC. Water is pumped through the water block,
which removes the excess heat from overclocking. You’ll then need to test
the water block for leaks and, finally, install it on top of the CPU and con-
nect the water piping.
This specific water block was designed with a few simple rules in mind:
the space inside of a PC is limited, so the system should easily fit; it should
cool an AMD or Pentium CPU; and it should be easy to secure the cooler ...