Time Code — Initializing the System
In practice the master time is normally taken from the time code clock inside the Nagra IV-S T.C. recorder.
Transferring Data From the Nagra to the ORIGIN C Unit
- Verify that the Nagra is in dAtE Ub mode (see page 224).
- Put the Nagra into TEST mode.
- Switch the ORIGIN C unit ON, plug it into the Nagra recorder and press the “” key. The display should show In Control then Good. If not press the “” key again.
- Disconnect the ORIGIN C unit from the Nagra but do not switch it OFF.
Transferring Data From the ORIGIN C Unit to the Camera
- Check that power is connected to the camera.
- Plug the ORIGIN C into the camera unit socket and press the “” key.
- The display will read bAd....REIoAd? While REIoAd is displayed again ...