
INTRODUCTION TO NXT-G 89
Display Specify whether the Switch block should be on
flat view or not. In flat view (shown), both sequence beam
paths are visible. With flat view turned off, the Switch
block presents tabs that you must click to view the differ-
ent sequence beam paths.
Port Specify which input port the touch sensor is using
on the NXT.
Action Specify which condition to test for: the touch
sensor is pressed, the touch sensor is released, or the
touch sensor is bumped (i.e., pressed and then released).
NOTE For more information about the Switch block and
the Loop block and all of their possible configurations,
consult the NXT-G document ...