
WARNING: HARDWARE HARM
The two screws at the top are shorter than the rest, so you’ll need to be careful to insert the
longer screws into the correct holes when reassembling the 5200. Failure to do so can result
in damage to the case, especially if you insert a long screw into a hole meant for one of the
shorter screws.
2. After removing the screws, turn the 5200 back over and slowly remove the top of the case,
exposing the PCB inside.
■
If the RF cable is plugged into the board as shown in Figure 8.6, unplug it first.
www.syngress.com
252 Chapter 8 • Hack Your Atari 5200 and 8-Bit Computer
Figure 8.5 Screw Locations of the Atari 5200
Figure 8.6 Unplug the ...