
12. After replacing the rubber pads, place the battery on top of the hard drive.Take care to
properly align the battery on top of the hard drive, or you may have problems getting the
case back together. Also, tuck the battery power cable underneath the metal housing at the
top of the iPod to move it out of the way (see Figure 11.52). Apply enough pressure to the
battery to ensure that it is firmly attached to the rubber pads.
13. Fold the two pieces of metal foil back over the battery. Finally, snap the stainless steel cover
back over the case (see Figure 11.53). If the cover does not slide easily over the case, make
sure there are no obstructions before ...