
Inserting the New LEDs
When you have successfully removed all the old LEDs, the next step is to prepare for inserting the
new ones.
1. Make sure you remove the excess solder from the pads from which the LEDs were just
removed. Next, use some alcohol or flux remover to clean away any residue.
2. When you are satisfied that the board is properly cleaned, it is time to fit in the new LEDs.
It is important to realize that the LEDs are actually shining through the PCB to the other
side from where they are attached.To see if they fit properly into the circuit board, place
one of them over the hole (where the light shines through) with a pair of tweezers. In the ...