
Power Me Up, Scotty!
The final step of the hack is to power up the device with JP2 shorted and the SRAM card installed.
You should observe a green LED and a yellow LED flashing alternately. Once you see this flashing,
release the JP2 jumper by removing your paper clip or wire while keeping the device powered up. Be
careful not to touch any other components with the paperclip or wire. When the install from SRAM
is complete, the device will reboot itself and (assuming the JP2 short is removed), will boot directly
from its on-board Flash.You can observe this process by noting that the green and yellow LEDs will
now flash back and forth more quickly.This process ...