December 2001
Intermediate to advanced
608 pages
25h 14m
English
hub — global
hub ethernethub-numberfirst-port[last-port]
Hub configuration mode
None
The hub command enters hub configuration mode, in
which you can enter commands that configure a hub. It is applicable
only to routers that are equipped with hub interfaces.
hub-number is the number of the hub that
you are configuring. first-port is the
beginning of a range of consecutive ports to be configured as part of
the hub; last-port is the last port in the
range. If you omit last-port, this command
adds a single port to the hub.
To configure one port of a hub:
hub ethernet 0 1 source-address 00:00:0c:ff:d0:04
To configure all ports of a hub:
hub ethernet 0 1 7 no link-test auto-polarity
Read now
Unlock full access