December 2001
Intermediate to advanced
608 pages
25h 14m
English
ip pim query-interval — interface
ip pim query-interval seconds
no ip pim query-interval The frequency of PIM query messages
30 seconds
This command sets the query interval to
seconds. The query message is used to
determine which router on the subnet will be the designated router.
The designated router sends IGMP messages to the rest of the routers
on the LAN; it also sends messages to the rendezvous point when
operating in sparse-mode. The query interval defaults to 30 seconds
and can be set to a value between 1 and 65535 seconds.
Read now
Unlock full access