December 2001
Intermediate to advanced
608 pages
25h 14m
English
ip access-group — interface
ip access-groupaccess-list[in | out] no ip access-groupaccess-list[in | out]
Assigns an access list to an interface
No access lists defined
This command applies the given access list to the interface in the
direction specified (in or
out). Access-list commands are discussed in Chapter 7. Each interface can support only one access
list in either direction.
The following commands apply access list 110 to filter incoming
packets on the serial1 interface, and access list
111 to filter outgoing packets:
interface serial1 ip access-group 110 in ip access-group 111 out
To remove an access list from an interface, use the
no form of this command:
interface serial1 no ip access-group 111 out
If you use the no
access-list
command, your access list will be deleted. Be sure to use
no
ip
access-group when removing lists from interfaces.
Read now
Unlock full access