
Chapter 11. Cisco initial setup 307
Figure 11-1 shows an example of the HyperTerminal serial port properties
window.
Figure 11-1 HyperTerminal serial Port Properties window
11.2.3 Setting up the initial parameters with the setup program
We assume that you are already connected to the console serial port of the
switch and that the switch is still turned off. In the following example, we connect
to a Cisco MDS 9216i.
To set up the initial parameters:
1. Turn on the switch, and at the Admin account setup window, enter your admin
password twice.
Note: The steps you take might be different depending on which features you
want to activate. However, the ...