
182 SAN Multiprotocol Routing: An Introduction and Implementation
FCIP configuration in GUI
In our example, we establish an FCIP tunnel between a SAN18B-R router and a
SAN Routing Blade. We use GigE port ge1 on both routers. SAN18B-R is
attached to a BladeCenter Fibre Switch Module because we use two Blade
servers as our hosts. These two Blade servers require access to the DS400
Storage Server logical drives and the DS400 is attached to the M48 Director. The
M48 contains two FC Routing Blades; in our example, we use the Routing Blade
in slot 10. Figure 6-74 on page 153 shows all of this.
Connection between the SAN18B-R and BladeCenter FSM
The ...