Chapter 6. IBM TotalStorage b-type router implementation 141
6.2 Installing the SAN18B-R and M48 FC Routing Blade
This section contains a detailed description of setting up the SAN18B-R and the
FC Routing Blade. We begin with the initial setup and then continue with the
FCIP and LSAN configuration. Finally, we mention the FCR administration.
Most of the procedures are exactly the same on the SAN18B-R and the Routing
Blade. There are some differences in the initial setup part, because the Routing
Blade is installed in the M48 Director. We perform some initial tasks, such as IP
address configuration, not on the FC Routing Blade, but on the CP blade in M48
Director.
The main installation and configuration tasks are as follows:
1. Set up IP add ...