
484 SAN Multiprotocol Routing: An Introduction and Implementation
To configure SNMP trap recipients, select Configuration → System → SNMP
Traps and enter up to eight IP addresses, as shown in Figure 17-38.
Figure 17-38 Defining SNMP Trap recipients
Save this change to flash memory after making the other configuration changes.
17.6.5 Inband IP address
As listed in 17.5, “Example configuration” on page 479, we use an inband
address of 192.168.111.100 for our routers. Select Configuration → System →
Inband Address and verify that the address and mask are correctly set. If this
address is changed, a router reset will be required for it to take eff ...