July 2005
Intermediate to advanced
768 pages
13h 12m
English
The raster moves up so the menu bar is no longer visible. Use the following procedure to replace the IVAD (Integrated Voltage Analog Data) cable:
1. | Remove the rear housing from the eMac. |
2. | Discharge the CRT.
NOTE Warning: The eMac contains high voltage and a high-vacuum picture tube. To prevent injury, follow the discharge instructions in Lesson 10, “Cathode-Ray Tubes.” |
3. | Locate the IVAD assembly, shown in the following photograph. Remove the screw (circled in the photograph) and then remove the metal cable cover.
NOTE You must remove the screws on the IVAD assembly to access one end of the IVAD cable.
|
4. | Remove the remaining ... |
Read now
Unlock full access