HA stateful switchover
In the deployments previously discussed, the services will switch over to the backup WLC if the primary or active WLC fails. However, the clients connected to the APs will be disconnected and have to be authenticated again before getting connected once the WLC switchover happens, as there is no synchronization of the state between the WLCs and they work independently of each other. In the HA stateful mode, two WLCs are connected through an onboard redundancy port and they synchronize the working state over this link. Hence, when one of the WLC fails, the APs switch over to the backup WLC without any service disruption. The RPs need to be connected to a layer 2 network, either through a back-to-back cable or on the same ...
Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month,
and much more.
Read now
Unlock full access